Support Circuits

Chips, boards, reference designs for implementing our sensors

Complementary ICs

Royal Philips Electronics has manufactured limited numbers of chips designed specifically to drive and interface with some of our sensors, including clock drivers, pulse generators, DC-DC converters, and A-D converters.

• TDA9991HL
  • Provides eight two-(or three-) level low-ohmic line drivers for FT and FF CCD image sensors.
  • Versatile programmable DC-DC converters and voltage regulators create all required low-noise supply voltages for DALSA image sensors.
  • Available from DALSA
  • View datasheet
• SAA8103
  • Generates all pulses for FT and FF image sensors up to 8K x 8K
  • 4 image clocks, 4 storage clocks, TG, CR
  • Line and frame synchronization signals
  • 9 programmable HF-output with 1/24 clock-period accuracy (C-clocks, RG, SG, CDS pulses, ADC pulse)
  • I2C control
  • Available from DALSA
  • View datasheet

For more information on the availability and use of these products, contact Sales. And for additional information, check our Documents page for relevant Application Notes.

EKxxxx Sensor Evaluation Kit and Reference Design

Download EKxxxx Datasheet

The EKxxxx Evaluation kit is a platform to evaluate the DALSA CCD imagers for DSC, medical and industrial applications. The kit consists of an interface board and a reference design that contains all electronics needed to operate the imager as it would be in a final application.

In addition to the chipset, a simple microcontroller is used in the reference design on the chipset board. This microcontroller handles the tasks of power management and system configuration, making high start-up speeds possible. LabVIEW-based software is used to control the kit via a RS232 cable.

Features:

• Supports FTT1010M (1M), FT18 (1M), FTF2416 (4M), FTF3020 (6M), FTF4027 (11M), FTF4052 (22M), FTF5066 (33M), and FTF7040M (28M) sensors
• Available for most DALSA full-frame and frame-transfer CCD image sensors
• Choice of LVDS or CameraLink framegrabber interfaces
• Full chipset including timing generator and analog front-end
• Microprocessor for system control & power management
• Powered by single 6V DC-voltage supply
• Accurate gain and black level control
• Fully configurable via LabVIEW software
• Programmable synchronisation pulses for optics (LED or shutter)

  For more information email  sales.sensors@dalsa.com.

  
  

  ---

  ©2008 DALSA • Privacy Policy
  Problems with this site? E-mail the webmaster.